NI SCXI-1100 dual-wire serial interface
NI SCXI-1100 dual-wire serial interface
NI SCXI-1100 dual-wire serial interface
NI SCXI-1100 dual-wire serial interface

NI SCXI-1100 dual-wire serial interface

1.Warranty time: 1 year

2.Delivery time: 3-5 days

3.Product quality: new or discontinued second-hand

1. We are a global trading company, we have a large stock of spare parts, we also produce energy storage batteries

2. Our main sales products are industrial automation control equipment accessories, such as: controller board, processor module, communication module, input and output module, power module (various circuit boards and cards), touch screen, servo driver, servo motor, sensor, cable......

3. We can not only provide new products, but also supply cold and discontinued spare parts, all the discontinued parts will go through strict testing to ensure the reliability of product performance, so that customers can buy and use at ease

4. For more information, please contact us: Contact: Amy | Email: saul01@qq.com | Tel(WhatsApp/Wechat): +86-15359298283


NI SCXI-1100 dual-wire serial interface

NI SCXI-1100 dual-wire serial interface(图1)


NI SCXI-1100 dual-wire serial interface

NI SCXI-1100 dual-wire serial interface(图2)


NI SCXI-1100 dual-wire serial interface


NI SCXI-1100 National Instruments dual-wire serial interface address matching


SCXI-1100 To use this sleep mode, write the SM[2,0] bit to "001". This mode stops the CPU but allows the ADC, external interrupts, USART, two-wire serial interface, watchdog, and counter to work. ADC noise reduction mode basically stops the CLK CPU, CLK I /O and CLK flash. We can reduce noise mode from the wake controller ADC by the following methods:


External reset


The watchdog system resets


Guard dog interrupts


Power-off reset


Two-wire serial interface address matching


External level interrupt on INT


Pin change interrupt


The timer/counter is interrupted


SPM/EEPROM ready interrupt


Power saving mode


SCXI-1100 Power off mode stops all generated clocks and allows only asynchronous modules to work. It can be enabled by writing the SM[2,0] bit to "010". In this mode, the external oscillator is turned off, but the two-wire serial interface, watchdog, and external interrupts continue to work. It can only be disabled by one of the following methods:


External reset


The watchdog system resets


Guard dog interrupts


Power-off reset


Two-wire serial interface address matching


External level interrupt on INT


Pin change interrupt


Arduino code for power down cycle mode:


LowPower.powerDown(SLEEP_8S, ADC_OFF, BOD _OFF);


This code is used to enable power off mode. By using the code above, Arduino will go to sleep for eight seconds and wake up automatically.


We can also use a power-saving mode with interruptions, at which point the Arduino will go to sleep, but will only wake up if external or internal interruptions are provided.


Arduino code for power failure interrupt mode:


Invalid loop (){// Allows the wake pin to trigger an interrupt at low power levels. attachInterrupt(0, wake up, low); low power. power down(SLEEP _ FOREVER, ADC_OFF, BOD _OFF); // Disable external pin interrupts on wake pins.


NI SCXI-1100 dual-wire serial interface


Copyright Beixun Automation All Rights Reserved Sitemap

Follow Us
Disclaimers: All trademarks on the website are not owned by us. If there is any infrigement, wecan replace them at any time.