1. We are a global trading company, we have a large stock of spare parts, we also produce energy storage batteries

2. Our main sales products are industrial automation control equipment accessories, such as: controller board, processor module, communication module, input and output module, power module (various circuit boards and cards), touch screen, servo driver, servo motor, sensor, cable......

3. We can not only provide new products, but also supply cold and discontinued spare parts, all the discontinued parts will go through strict testing to ensure the reliability of product performance, so that customers can buy and use at ease

4. For more information, please contact us: Contact: Amy | Email: saul01@qq.com | Tel(WhatsApp/Wechat): +86-15359298283

1. How to use:

• Properly ground the ACS 800, motors and connected equipment to ensure worker safety and reduce electromagnetic radiation and interference under all circumstances.

• Ensure that the cross-sectional area of the ground conductor is large enough to meet the requirements of the safety specification.

• The ground terminals of multiple ACS 800 cannot be connected in series.

In compliance with the European CE standard and other installation sites where EMC radiation must be reduced, the cable inlet should be kept 360 degrees high frequency ground to suppress electromagnetic interference. In addition, the cable shield must be connected to the protective ground wire (PE) to comply with safety specifications. • Do not install inverter with EMC filter (optional +E202 or +E200) in power systems with floating or high ground resistance (>30Ohms).

2. Only qualified electrical engineers are allowed to install and maintain transmission units.

• Do not install or service transmission units, motor cables or motors while they are live. After cutting off the input power supply, wait at least 5 minutes until the intermediate circuit capacitor is discharged before performing the operation. A multimeter (impedance of at least 1 megohm) should also be used to determine that 1. The voltage between the transmission input phase U1,V1,W1 and the cabinet is close to 0V.2. The voltage between terminals UDC+ and UDC- and the cabinet is close to 0V.

• Do not operate the control cable when the drive unit or external control circuit is live. Even if the ACS 800 main power supply is disconnected, there may still be dangerous voltages introduced by the external control circuit.

• All insulation tests must be performed with the cable disconnected.

• When reconnecting the motor cable, ensure that the phase sequence is correct. Note:

• Motor cable terminals are exposed to dangerously high voltages whenever the input power to the ACS 800 drive is on, regardless of whether the motor is running.

• Brake control terminals (UDC+, UDC-, R+ and R-terminals) with dangerously high DC voltages (greater than 500 V).

• Relay output terminals RO1 to RO3 have dangerous high voltages when 115 V or 220 V (230 V) voltage is applied.

ABB controls the main board UFC762AE101 3BHE006412R0101

ABB controls the main board UFC762AE101 3BHE006412R0101

ABB controls the main board UFC762AE101 3BHE006412R0101

ABB controls the main board UFC762AE101 3BHE006412R0101

ABB controls the main board UFC762AE101 3BHE006412R0101